Four Wheel Antilock Brake System
NOTE: If the CAB needs to be replaced, the rear axle type and tire revolutions per mile must be programmed into the new CAB.REMOVAL
1. Disconnect battery negative cable.
Harness Connector Locks:
2. Push the harness connector locks to release the locks, then remove the connectors from the CAB.
Pump Motor Connector:
3. Disconnect the pump motor connector.
Controller Mounting Screws:
4. Remove screws attaching CAB to the HCU.
5. Remove the CAB.
INSTALLATION
1. Place the CAB onto the HCU.
NOTE: Insure the CAB seal is in position before installation.
2. Install the mounting screws and tighten to 4 - 4.7 Nm (36 - 42 inch lbs.).
3. Connect the pump motor harness.
4. Connect the harnesses to the CAB and lock the connectors.
5. Connect battery.