Wheel Hub: Service and Repair

REMOVAL
1. Raise and support vehicle.
2. Remove wheel and tire assembly.
3. Remove axle nut.
4. Remove ABS wheel speed sensor if equipped.
5. Remove the brake caliper and rotor.

Hub/Bearing:

6. Remove hub/bearing mounting bolts from the steering knuckle.
7. Slid hub/bearing out of the steering knuckle and off the axle.

INSTALLATION
1. Install the hub/bearing into the steering knuckle and tighten the bolts to 166 Nm (123 ft. lbs.).
2. Install the brake rotor and caliper.
3. Install ABS wheel speed sensor if equipped.
4. Install axle nut and tighten to 235 Nm (173 ft. lbs.) and install cotter pin.
5. Install wheel and tire assembly.
6. Remove support and lower vehicle.