Front Header Reading / Courtesy Lamp

REMOVAL

Battery Negative Cable:

1. Disconnect and isolate the battery negative cable.

Lamp And Lens Removal:

2. Place a small flat tool in the slot at the forward edge of the lamp lens and twist.
3. Remove lens.
4. Insert the tip of the tool under the inside, rear edge of the reflector / light shield. Carefully pry reflector / light shield out.
5. Remove the lamp by pressing forward the brass terminal and rotating the lamp clockwise to remove.

INSTALLATION
For installation, reverse the above procedures. When installing the lamp lens, first guide the switch contact tab on the lens between the lamp switch plunger and the lamp bezel. Then snap lens onto the two lens pivots on the bezel.