Rear Driveline Module Assembly

REMOVAL
1. Raise vehicle on hoist.

Fig. 2:

2. Remove right and left inner half shaft joint mounting bolts.
3. Support inner side of half shaft with mechanics wire or equivalent. Do not allow half shafts to hang freely.

Fig. 3:

4. Remove mounting bolts from the rear side of propeller shaft.

CAUTION: Do not allow propeller shaft to hang freely.

5. Support propeller shaft with mechanics wire and/or jack stand
6. Disconnect main vacuum line for rear drive line module assembly. Also disconnect electrical connections at the front of the module.
7. Support rear drive line module assembly with transmission jack or equivalent.

WARNING: BE SURE TO CHAIN REAR DRIVE LINE MODULE ASSEMBLY SECURELY TO THE JACK TO PREVENT IT FROM FALLING.

Fig. 4:

8. Remove rear drive line module assembly rear mounting bolts.

Fig. 5:

9. Remove rear drive line module assembly front mounting bolts.
10. Partially lower rear drive line module assembly and disconnect remote solenoid vent and remote carrier vent.
11. Remove rear drive line module assembly.

INSTALLATION
1. To install, reverse removal procedure. Refer to specifications for tightening information.