License Plate Lamp: Service and Repair

REMOVAL
1. Release liftgate latch and open liftgate.
2. Remove liftgate trim panel.
3. Remove water shield as necessary to gain access to back of license plate lamp bar.
4. Disconnect wire connector from liftgate wire harness.
5. Remove screws holding license plate lamp bar to liftgate.

License Plate Lamp:

6. Remove license plate lamp bar from liftgate.
7. Remove license plate lamp bar from vehicle.

NOTE: Wire connector may be disconnected at socket which eliminates removal of liftgate trim.

INSTALLATION
1. Place license plate lamp bar in position on liftgate.
2. Install screws to hold license plate lamp bar to liftgate.
3. Connect wire connector into liftgate wire harness.
4. Install water shield.
5. Install liftgate trim panel.
6. Verify license plate lamp operation.