Calibration Test
CLUSTER CALIBRATION TABLESpeedometer = Calibration Point
1 = 0 mph (0 Km/h)
2 = 20 mph (40 Km/h)
3 = 55 mph (80 Km/h)
4 = 75 mph (120 Km/h)
Tachometer = Calibration Point
1 = 0 rpm
2 = 1000 rpm
3 = 3000 rpm
4 = 6000 rpm
Fuel Gauge = Calibration Point
1 = Empty (E)
2 = 1/8 Filled
3 = 1/4 Filled
4 = Full (F)
Temperature Gauge = Calibration Point
1 = Cold (C)
2 = Low Normal
3 = High Normal
4 = Hot (H)
When CHEC-1 is displayed in the odometer window, each of the cluster's gauge pointers will move sequentially through each calibration point. The Calibration Table contains the proper calibration points for each gauge. If the gauge pointers are not calibrated, a problem exists in the cluster. If any gauge is out of calibration it will have to be calibrated using a DRB III� scan tool. Refer to the proper Body Diagnostic Procedure for calibration procedures.
Additional diagnostic trouble code information can be found at Body Control Module, Testing and Inspection, Diagnostic Charts. Testing and Inspection