Antenna Mast and Cable Lead

REMOVAL
1. Remove glove box from instrument panel, refer to Instrument Panel and Systems for proper procedures.

Antenna Cable:

2. Disconnect antenna cable connector from extension cable.
3. Remove right kick trim panel.
4. Remove fender splash shield.
5. Disengage rubber grommet insulator from door hinge pillar.
6. Pull antenna cable through hinge pillar into open between door hinges.
7. Hoist and support vehicle on safety stands.
8. Remove front wheel.
9. Remove front wheelhouse splash shield.

Antenna Mast:

10. Remove antenna mast from antenna base.

Antenna Cap Nut Remove/Install - Typical:

11. Remove plastic cap from the cap nut. Using cap nut tool, remove cap nut holding antenna base to front fender.
12. Remove antenna base from under front fender.

INSTALLATION
For installation, reverse the above procedure. Torque antenna base retaining nut to 28-32 in.lbs.