Instrument Cluster Printed Circuit Board Replacement

REMOVAL
1. Remove the instrument cluster. Refer to Instrument Cluster with Mechanical Transmission Range Indicator Replacement.
2. Remove the instrument cluster back panel.

Instrument Cluster Printed Circuit Board:

3. Disconnect the electronic cluster wire connector from the printed circuit board.
4. Remove the screws holding wire connector insulator to the instrument cluster shell and the printed circuit board.
5. Remove the screws holding printed circuit board to the cluster shell.
6. Remove the printed circuit board from the cluster.

INSTALLATION
For installation, reverse the above procedures. After installing the print circuit board it will have to be calibrated using a scan tool (DRB III). Refer to the proper Body Diagnostic Procedure for calibration procedures.

NOTE: Speedometer and/or Tachometer will not operate properly until all gauges have been calibrated