Turn Signal Switch: Testing and Inspection

To test turn signal, headlamp beam select and optical horn portion of the multi-function switch:
1. Remove the multi-function switch, refer to removal procedures.

Turn Signal - Multi-Function Switch Pin Numbers:

2. Using an ohmmeter check continuity reading between multi-function switch pins. Refer to the above image for proper pin numbers and Turn Signal Multi-Function Switch Test table.

TURN SIGNAL / MULTI-FUNCTION SWITCH TEST TABLE
Switch position = Continuity Between
Left = 4 and 8
Right = 3 and 8
Hazard = 1 and 8
LO beam = 9 and 10
HI beam = 9 and 12