Loss of Ignition Run Only (Active)

SYMPTOM
LOSS OF IGNITION RUN ONLY (ACTIVE)

WHEN MONITORED
Continuously with ignition ON.

SET CONDITION
If the voltage on the fused ignition switch output Run Only circuit drops below 4.5 volts the code will set.

POSSIBLE CAUSES
- Active code present only with PAB ON/OFF SW OFF
- Ignition switch output CKT open
- Fuse # 18 defective
- Fused ignition switch output CKT short to GND
- Fused ignition switch output CKT open
- Airbag Control Module defective, fused ignition switch short to ground
- Airbag Control Module defective, fused ignition switch CKT open