System Specifications

Tighten the three screws that secure the cubby bin to the instrument panel to 2.2 Nm (20 in lbs).

Tighten the four screws that secure the instrument cluster to the instrument panel to 2.2 Nm (20 in lbs).

Tighten the seven screws that secure the lens and hood unit to the cluster housing to 2.2 Nm (20 in lbs).

Tighten the six screws that secure the rear cover to the back of the cluster housing to 2.2 Nm (20 in lbs).

Tighten the five screws that secure the top of the instrument panel to the top of the dash panel to 3.2 Nm (28 in lbs).

Tighten the right and left instrument panel cowl side roll-down bracket screws to 11.9 Nm (105 in lbs).

Tighten the instrument panel bulkhead wire harness connector screw in the center of the connector to 3.5 Nm (31 in lbs).

Tighten the two screws that secure the inside hood latch release handle to the instrument panel lower reinforcement to 2.8 Nm (25 in lbs).

Tighten the screws around the perimeter of the top cover that secure it to the instrument panel base, the defroster duct and the demister ducts to 2.2 Nm (20 in lbs).