Glove Box Bin Replacement

GLOVE BOX BIN

Glove Box Bin Remove/Install:

The only serviced component of the glove box is the glove box bin. If any other component of the glove box is faulty or damaged, the entire glove box assembly must be replaced.

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the glove box from the instrument panel. Refer to Glove Box in the Replacement for the procedures.
3. Remove the two screws that secure each outboard flange of the glove box bin to the glove box door.
4. Pull the top of the bin away from the top of the glove box door.
5. Disengage the five hook formations on the bottom of the glove box bin from the slots near the bottom of the inner glove box door.
6. Remove the glove box bin from the glove box door.

INSTALLATION
1.Position the glove box bin onto the glove box door.
2. Engage the five hook formations on the bottom of the glove box bin with the slots near the bottom of the inner glove box door.
3. Position the top of the bin to the top of the glove box door.
4. Install and tighten the two screws that secure each outboard flange of the glove box bin to the glove box door. Tighten the screws to 2.2 Nm (20 in lbs).
5. Install the glove box onto the instrument panel. Refer to Glove Box in the Replacement for the procedures.
6. Reconnect the battery negative cable.