DN Vehicles

1. Open the driver's door.

2. Using a small flat blade, pry the turning loop cover open.

3. Remove the turning loop attaching bolt and disconnect the turning loop from the height adjuster.

4. Remove the lower seat belt anchor bolt from the driver's seat.

5. Remove the driver's door sill plate.

6. Remove the upper B-Pillar trim panel.

7. Remove the lower B-Pillar trim panel.

8. Disconnect the retractor electrical connector.

9. Remove the anchor bolt that attaches the retractor to the B-pillar.

10. Remove and discard the retractor assembly.

11. Remove the anti-rotation tab from the new retractor assembly and then install the new retractor assembly.

12. Install the retractor anchor bolt. Tighten the bolt to 30 ft-lbs (41 Nm)

13. Connect the retractor electrical connector.

14. Install the lower B-pillar trim panel.

15. Install the upper B-pillar trim panel.

16. Install the driver's door sill plate.

17. Install the lower seat belt anchor bolt (Figure 3). Tighten the bolt to 17 ft-lbs (23 Nm)

18. Install the turning loop anchor bolt. Tighten the bolt to 30 ft-lbs (41 Nm)

19. Close the turning loop cover.

20. Repeat Steps 1-19 for the passenger side of the vehicle.