WJ Vehicles

1. Open the driver's door.

2. Using a small flat blade, pry the turning loop cover open.

3. Remove the turning loop attaching bolt and disconnect the turning loop from the height adjuster.

4. Remove the lower seat belt anchor bolt.

5. Remove the driver's door sill plate.

6. Remove the lower B-Pillar trim panel.

7. Remove and discard the retractor assembly.

8. Install the new retractor assembly.

9. Install the lower B-pillar trim panel.

10. Install the driver's door sill plate.

11. Install the lower seat belt anchor bolt. Tighten the bolt to 30 ft-lbs (41 Nm)

12. Install the turning loop anchor bolt. Tighten the bolt to 30 ft-lbs (41 Nm)

13. Close the turning loop cover.

14. Repeat Steps 1-13 for the passenger side of the vehicle.