AB Vans/Wagons

IMPORTANT:
Ram Vans/Wagons equipped with a sliding door require right (passenger side) front seat belt retractor assembly replacement only.

1. Open the passenger side doors.

2. Using a small flat blade, pry the turning loop cover open.

3. Remove the turning loop attaching bolt and disconnect the turning loop from the height adjuster.

4. Remove the retractor/seat belt lower anchor bolt from the front seat riser.

5. Remove and discard the retractor assembly.

6. Install the new retractor assembly.

7. Install the retractor/seat belt anchor bolt. Tighten the bolt to 30 ft-lbs (41 Nm)

8. Install the turning loop anchor bolt. Tighten the bolt to 30 ft-lbs (41 Nm)

9. Close the turning loop cover.

10. For vehicles equipped with dual hinged side doors, repeat Steps 1-9 for the driver's side of the vehicle.