LH Vehicles

1. Using a small flat blade, pry the turning loop cover open.

2. Remove the turning loop attaching bolt and disconnect the turning loop from the height adjuster.

3. Remove the seat belt/retractor lower anchor bolt.

4. Remove the upper B-Pillar trim panel.

5. Remove the lower B-Pillar trim panel.

6. Remove and discard the retractor assembly.

7. Install the new retractor assembly.

8. Install the lower B-pillar trim panel.

9. Install the upper B-pillar trim panel.

10. Install the seat belt/retractor lower anchor bolt.
Tighten the bolt to 30 ft-lbs (41 Nm)

11. Install the turning loop anchor bolt. Tighten the bolt to 30 ft-lbs (41 Nm)

12. Close the turning loop cover.

13. Repeat Steps 1-12 for the other side of the vehicle.