Clutch Housing

1. Remove the bolts holding the input shaft retainer onto the clutch housing.

Fig. 63:

2. Separate the input shaft retainer from the clutch housing.

Fig. 64:

3. Remove the countershaft oil guide from the countershaft front bearing bore in the clutch housing.

Fig. 65:

4. Using Remover 6061-1 and Handle C-4171, remove the countershaft front bearing race, end play shines, and spacer from the clutch housing.
5. Using Remover/Installer 8237 and Handle C-4171, remove the input shaft bearing race.

Fig. 66:

6. Remove the input shaft oil guide and retainer seal.