Drive Gear Removal

Fig. 41:

1. Remove drive gear.

Fig. 42:

2. Remove pilot bearing from drive gear.
3. Remove tapered bearing from drive gear as follows:

Fig. 43:

a. Assemble Puller Flange 6444-1 and Puller Rods 6444-6. Then position first Puller Jaw 6447 on bearing.
b. Slide assembled puller flange and rod tools onto input shaft. Then seat flange in notch of puller jaw.
c. Position second Puller Jaw 6447 on gear and in notch of puller flange.
d. Slide Retaining Collar 6444-8 over puller jaws to hold them in place.
e. Install Puller 6444 on puller rods. Then secure puller to rods with retaining nuts.
f. Tighten puller bolt to remove bearing cone from drive gear.