Clutch Housing

1. Using Remover/Installer 8237 and Handle C-4171, install the input shaft bearing race 0.3 inch beyond flush with the front of the clutch housing.
2. Using Remover 6061-1 and Handle C-4171, install the countershaft front bearing race into the clutch housing 0.4 inch beyond flush with the front of the clutch housing.

Fig. 92:

3. Install the countershaft oil guide and spacer into the countershaft front bearing bore in the clutch housing.
4. Clean all old sealer from the input shaft retainer and the clutch housing but DO NOT apply new sealer at this time. New sealer will be applied after all the preload measurements are made and endplay shims are installed.
5. Do not replace the input shaft seal at this time. A new seal will be installed after all the preload measurements are made and endplay shims are installed.
6. Position the input shaft retainer onto the clutch housing.
7. Install the bolts to hold the input shaft retainer onto the clutch housing.