Transmission Gear Case

1. Using Installer C-4308 and Handle C-4171, install the rear output shaft bearing race into the transmission gear case.
2. Using Installer 8153 and Handle C-4171, install the rear countershaft bearing race into the transmission gear case.
3. Install Fixture 8232 to the transmission gear case.

Fig. 99:

4. Attach an engine crane, or equivalent, to Fixture 8232 and install the transmission gear case onto the clutch housing.
5. Install the bolts to hold the transmission gear case to the clutch housing. Torque the bolts to 48 Nm (35 ft. lbs.).
6. Using a suitable punch and hammer, install the shift socket roll pin. The correct size punch is 6 mm (7/32 inch).