Low/Reverse Servo

DISASSEMBLY





1. Back off low/reverse band adjustment and position lever out of the way (Fig. 204).





2. Remove low/reverse servo snap ring (Fig. 205).





3. Remove retainer, spring and servo (Fig. 206).

CLEANING





Remove and discard the servo piston seal ring (Fig. 207). Then clean the servo components with solvent and dry with compressed air. Replace either spring if collapsed, distorted or broken. Replace the plug and piston if cracked, bent, or worn. Discard the servo snap-rings and use new ones at assembly.

ASSEMBLY





1. Install low/reverse servo assembly (Fig. 208).





2. Install low/reverse servo snap ring (Fig. 205).