Assembly

ASSEMBLY





1. Install shift/shuttle valves and springs as shown in (Fig. 320).





2. Install torque converter clutch solenoid, spring, and plug as shown in (Fig. 319).





3. Install governor plugs as shown in (Fig. 318).





4. Install pressure regulator and manual control springs and valves as shown in (Fig. 317).





5. Install pressure regulator spring retainer/adjusting screw bracket (Fig. 321).





6. Install manual valve from valve body (Fig. 322).





7. Install throttle valve lever/shaft (Fig. 323).





8. Install manual valve shaft/lever to throttle valve shaft (Fig. 324). Align manual valve lever to manual valve.





9. Remove throttle valve shaft-to-manual valve shaft seal, washer, and e-clip (Fig. 325). Verify that manual valve lever is engaged with manual valve.





10. Install and verify proper location of check balls (Fig. 326).





11. Install transfer and separator plate to valve body assembly (Fig. 327).








12. Using Tool L-4553 or equivalent (Fig. 328), install and torque valve body-to-transfer plate screws (Fig. 329) to 5 Nm (40 inch lbs.) torque.





13. Install detent spring into position. Install and torque detent spring-to-valve body screws to 5 Nm (40 inch lbs.) torque (Fig. 330).