Front Blower Motor

REMOVAL
1. Remove and disassemble the heater-A/C housing. Refer to: Heating and Air Conditioning, Housing Assembly HVAC, Service and Repair, Front, Front HVAC Unit Removal and Installation, Front HVAC Housing Removal and Installation

Blower Motor Remove/Install:

2. Remove the three screws that secure the blower motor, air spoiler, and blower wheel assembly to the heater-A/C housing.
3. Pull the blower motor and wheel assembly out of the passenger compartment side of the heater-A/C housing while feeding the blower motor wire harness, grommet and connector through the hole on the dash panel side of the housing.

Blower Motor Wheel Remove/Install:

4. Remove the blower wheel retainer clip and remove the wheel from the blower motor shaft.

INSTALLATION
1. Press the blower wheel hub onto the blower motor shaft. Be sure the flat on the blower motor shaft is indexed to the flat on the inside of the blower wheel hub.
2. Install the retainer clip over the blower wheel hub. The ears of the retainer clip must be indexed over the flats on the blower motor shaft and blower wheel hub.
3. Place the blower motor, air spoiler, and wheel assembly inside the heater-A/C housing and feed the blower motor wire harness connector through the grommet hole in the dash panel side of the housing.
4. Pull the blower motor wiring through the hole from the dash panel side of the heater-A/C housing until the grommet is seated, while positioning the blower motor and blower wheel assembly inside the housing.
5. Install the three screws that secure the blower motor, air spoiler, and wheel assembly to the heater- A/C housing. Tighten the screws to 2.2 Nm (20 in. lbs.).
6. Assemble and install the heater-A/C housing. Refer to: Heating and Air Conditioning, Housing Assembly HVAC, Service and Repair, Front, Front HVAC Unit Removal and Installation, Front HVAC Housing Removal and Installation