Brake Lamp: Service and Repair

Tail/Brake/Turn Signal/Back-Up Lamp Replacement

REMOVAL
1. Release liftgate latch and open liftgate.

Liftgate/Cargo Lamp:

2. Remove screws attaching tail, brake, turn signal and back-up lamp to liftgate opening.
3. Separate inner end of lamp from quarter panel.
4. Disengage hook holding outer end of lamp to quarter panel opening.
5. Separate lamp from quarter panel.

Tail, Brake, Turn Signal And Back-up Lamp:

6. Disengage positive lock on wire connector.
7. Depress lock tab on the side of the body harness connector.
8. Disengage wire connector from tail lamp circuit board.
9. Separate tail lamp from vehicle.

INSTALLATION
1. Place tail lamp in position on vehicle.
2. Engage wire connector into tail lamp circuit board.
3. Engage positive lock on wire connector.
4. Place lamp in position in position on quarter panel.
5. Engage hook to hold outer end of lamp to quarter panel opening.
6. Position inner end of lamp into quarter panel.
7. Install screws attaching tail, stop, turn signal and back-up lamp to liftgate opening.