Sliding Door Lock Plunger Replacement

REMOVAL

Negative Battery Cable:

1. Disconnect and isolate the negative battery cable.
2. Remove sliding door trim panel.
3. Remove sound pad as necessary to gain access to push-in fasteners holding sliding door lock plunger wiring harness to inner door panel.

Sliding Door Lock Plunger:

4. Make note of wiring harness routing to aid installation.
5. Remove push-in fasteners holding lock plunger wiring harness to inner door panel.
6. Disconnect plunger wiring harness from sliding door lock motor.
7. Remove screw holding lock plunger to door frame.
8. Remove lock plunger from sliding door.

INSTALLATION
For installation, reverse the above procedures