Hood Latch Release Cable: Service and Repair

LATCH RELEASE CABLE/HANDLE ASSEMBLY

REMOVAL

1. Remove the hood latch.
2. Remove the batter tray.
3. Disconnect the three cable push pin fasteners.
4. From inside the cab loosen the two handle screws and disconnect the handle from the instrument panel bracket.
5. Separate the grommet at the cowl panel and remove cable through the cab.

INSTALLATION

1. Route the cable/handle assembly through the cowl panel and install the grommet.
2. Position the handle onto the instrument panel bracket and tighten the screws.
3. Route the cable along the fender rails and install the three push pin fasteners.
4. Install the latch.
5. Install the battery tray.