Four Wheel Antilock System

NOTE: If the CAB needs to be replaced, the rear axle type and tire revolutions per mile must be programmed into the new CAB. For axle type refer to Transmission and Drivetrain, Differential. For tire revolutions per mile refer Steering and Suspension, Tires, Wheels and Alignment. To program the CAB refer to Antilock Brake System, Testing and Inspection, Procedures.

REMOVAL
1. Disconnect battery cables and remove the battery.
2. Remove the power distribution center.
3. Remove the battery and power distribution center mount.
4. Remove the washer reservoir mounting screws.
5. Lift up the reservoir and disconnect the pump motor connector and pump hose.
6. Remove the reservoir from the engine compartment.






7. Push the harness connector locks to release the locks, then remove the connectors from the CAB.






8. Disconnect the pump motor connector.






9. Remove screws attaching CAB to the HCU.
10. Remove the CAB.

INSTALLATION
1. Place the CAB onto the HCU.

NOTE: Insure the CAB seal is in position before installation.

2. Install the mounting screws and tighten to 4.4 Nm (39 inch lbs.).
3. Connect the pump motor harness.
4. Connect the harnesses to the CAB and lock the connectors.
5. Install the reservoir in the engine compartment. Connect the pump motor connector and pump hose.
6. Install the washer reservoir mounting screws.
7. Install the battery and power distribution center mount.
8. Install the power distribution center.
9. Install the battery and battery cables.