Rear Wheel Antilock System

NOTE: If the CAB needs to be replaced, the rear axle type and tire revolutions per mile must be programmed into the new CAB. For axle type refer to Transmission and Drivetrain, Differential. For tire revolutions per mile refer Steering and Suspension, Tires, Wheels and Alignment. To program the CAB refer to Antilock Brake System, Testing and Inspection, Procedures.

REMOVAL






1. Remove the washer reservoir mounting screws.
2. Lift up the reservoir and disconnect the pump motor connector and pump hose.
3. Remove the reservoir from the engine compartment.
4. Disconnect battery cables and remove the battery.
5. Remove the power distribution center.
6. Remove the battery and power distribution center mount.
7. Remove the RWAL valve harness.






8. Pull up on the CAB harness connector lock release and remove the connector from the controller.
9. Remove controller mounting screws and

INSTALLATION
1. Position the controller on the mounting bracket and install the mounting screws.
2. Install the CAB harness connector into the controller and push down on the connector lock.
3. Install the RWAL valve harness connector into controller.
4. Install the battery and power distribution center mount.
5. Install the power distribution center.
6. Install the battery and battery cables.
7. Install the reservoir in the engine compartment. Connect the pump motor connector and pump hose.
8. Install the washer reservoir mounting screws.