Rear Band Adjustment
OVERVIEWThe transmission oil pan must be removed for access to the rear band adjusting screw.
1. Raise vehicle.
2. Remove transmission oil pan and drain fluid.
3. Loosen band adjusting screw locknut 5-6 turns. Be sure adjusting screw turns freely in lever.
Fig. 314:
4. Tighten adjusting screw to 8 Nm (72 inch lbs.) torque (Fig. 314).
46RE TRANSMISSION
- Back off adjusting screw 2 turns.
- Hold adjusting screw in place and tighten locknut to 34 Nm (25 ft. lbs.) torque.
47RE TRANSMISSION
- Back off adjusting screw 3 turns.
- Hold adjusting screw in place and tighten locknut to 34 Nm (25 ft. lbs.) torque.
5. Position new gasket on oil pan and install pan on transmission. Tighten pan bolts to 17 Nm (13 ft. lbs.) torque.
6. Lower vehicle and refill transmission with Mopar ATF +4, type 9602 fluid.