Seat Flipper Side Shields - Second Row

SEAT FLIPPER SIDE SHIELDS - SECOND ROW - STOW - N - GO

REMOVAL

1. Remove two upper seat cushion side shields.
2. Remove seat lower cushion side shields - O/B & I/B.
3. Without flipping shield up, carefully lift shield vertically to disengage two plastic clips from the two small rods, one on cushion frame and rear one on riser assembly.
4. Using needle nose pliers, lift the spring leg upwards to disengage it from the rear small rod on riser assembly.
5. Repeat steps (1) & (2) for flipper side shield on opposite side of seat.
6. Repeat steps (1), (2), (3) for other seat.

INSTALLATION

1. Position flipper shield position on seat.
2. Using needle nose pliers, hook spring leg over rear small rod on risers assembly.
3. Snap two plastic clips to the two small rods, one on cushion frame and one towards rear of riser assembly (same rod spring leg is on).
4. Repeat steps (1), (2), & (3) for opposite flipper shield on opposite side of seat.
5. Repeat steps (1), (2), (3), & (4) for other seat.
6. Install seat lower cushion side shields - O/B & I/B.
7. Install seat upper cushion side shields.