Selector Switch/Transfer Case Mismatch

SELECTOR SWITCH/TRANSFER CASE MISMATCH

When Monitored and Set Condition: SELECTOR SWITCH/TRANSFER CASE MISMATCH
When Monitored: Continuously with ignition on.
Set Condition: The Transfer Case Control Module detects a mismatch between the Transfer Case Identification in the Transfer Case Control Module and the Transfer Case Selector Switch. The resistance difference between the 233/2WD and the 244/AWD Selector Switches enables the Transfer Case Control Module to Identify which switch is present.

POSSIBLE CAUSES:
CHARGING SYSTEM DTCS PRESENT
OTHER TRANSFER CASE DTCS PRESENT
VERIFY MODULE TYPE 233/2WD
VERIFY MODULE TYPE 244/AWD
VERIFY SELECTOR SWITCH 233/2WD
VERIFY SELECTOR SWITCH 244/AWD
INTERMITTENT WIRING AND CONNECTORS
5 VOLT SUPPLY CIRCUIT OPEN
MODE SELECT CIRCUIT C)PEN
TRANSFER CASE SELECTOR SWITCH 233/2WD
TRANSFER CASE SELECTOR SWITCH 244/AWD
TRANSFER CASE CONTROL MODULE