Transfer Case Selector Switch Error

TRANSFER CASE SELECTOR SWITCH ERROR

When Monitored and Set Condition: TRANSFER CASE SELECTOR SWITCH ERROR
When Monitored: Continuously with key on
Set Condition: This code is set whenever Transfer Case Control Module (TCCM) detects a Selector Switch input of less than 250 ohms or more than 14.5k ohms. This code will also set whenever TCCM detects a Selector Switch input of .25 volts or less, or 6 volts or more.

POSSIBLE CAUSES:
INTERMITTENT WIRING AND CONNECTORS
MODE SELECT CIRCUIT OPEN
MODE SELECT CIRCUIT SHORT GND
MODE SELECT CIRCUIT SHORT VOLT
5 VOLT SELECTOR SWITCH SUPPLY CIRCUIT OPEN
TRANSFER CASE SELECTOR SWITCH
TRANSFER CASE CONTROL MODULE