Horn: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.

Horn Relay Remove/Install:

2. Disconnect the headlamp and dash wire harness connectors from the horn connector receptacles.
3. Remove the screw that secures the horn and mounting bracket unit to the front of the left vertical member of the radiator support.
4. Remove the horn and mounting bracket unit from the radiator support.

INSTALLATION
1. Position the horn and mounting bracket unit onto the front of the left vertical member of the radiator support.
2. Install and tighten the screw that secures the horn and mounting bracket unit to the radiator support. Tighten the screw to 10.7 Nm (95 in. lbs.).
3. Reconnect the headlamp and dash wire harness connectors to the horn connector receptacles.
4. Reconnect the battery negative cable.