Outside Rearview Mirror Glass

SIDE VIEW MIRROR GLASS

REMOVAL

WARNING: ALWAYS WEAR EYE AND HAND PROTECTION WHEN SERVICING THE MIRROR ASSEMBLY. FAILURE TO OBSERVE THESE WARNINGS MAY RESULT IN PERSONAL INJURY FROM BROKEN GLASS.

Standard Mirror

Fig. 16:

1. Position the mirror glass so that it's facing in toward the vehicle as far as possible. (Fig. 16)

Fig. 17:

2. Disengage the rear housing cover retaining tabs and remove the cover. (Fig. 17)

Fig. 18:

3. Disengage the lower glass retaining tab to motor. (Fig. 18)
4. Slide glass up and remove from motor.
5. Disconnect the two heated mirror electrical connectors, if equipped.

Tow Package Mirror

Fig. 19:

1. Position the mirror in the out position. (Fig. 19)
2. Release the retaining clip and separate the glass.

Fig. 20:

3. Disconnect the four heated glass electrical connectors, if equipped. (Fig. 20)

INSTALLATION

Standard Mirror

Fig. 21:

1. Connect the two heated mirror electrical connectors, if equipped. (Fig. 21)

Fig. 22:

2. Position the mirror glass mounting holes over the four feet of the mirror motor and slide down. (Fig. 22)
3. Engage the lower glass retaining tab to the motor. (Fig. 18)
4. Position the rear housing cover and seat the retaining tabs fully. (Fig. 17)

Tow Package Mirror

1. Make sure the retaining clip is seated in the closed position on the mirror glass.
2. Connect the heated mirror electrical connectors, if equipped.

NOTE: Pressure must be applied equally over the center portion of the mirror to engage the mirror glass retaining clip fully.

3. Position the glass over the motor mounting and seat fully. Make sure the retaining clip seats fully.