Headlamp Replacement

REMOVAL
On the driver side, the battery and battery tray must be removed to service the headlamp bulb.
1. Disconnect and isolate the battery negative cable.
2. Remove the battery tray (Refer to BATTERY SYSTEM/TRAY - REMOVAL).
3. Disengage wire connector from headlamp bulb(s).

Fig.13 Headlamp Bulb:

4. Remove retaining ring holding bulb(s) to headlamp.
5. Pull bulb(s) from headlamp.

INSTALLATION

CAUTION: Do not touch the bulb glass with fingers or other oily surfaces. Reduced bulb life will result.

1. Position bulb(s) in headlamp.
2. Install retaining ring holding bulb(s) to headlamp.
3. Connect wire connector to headlamp bulb(s).
4. Install battery tray, if removed (Refer to BATTERY SYSTEM/TRAY - INSTALLATION).
5. Connect battery negative cable.