Electronic Brake Control Module: Service and Repair

REMOVAL
1. Disconnect battery negative cable.

Fig.11 Harness Connector Locks:

2. Push the harness connector locks to release the locks, then remove the connectors from the CAB.

Fig.12 Pump:

3. Disconnect the pump motor connector

Fig.13 Controller Mounting Screws:

4. Remove screws attaching CAB to the HCU.
5. Remove the CAB.

INSTALLATION
1. Place the CAB onto the HCU.

NOTE: Insure the CAB seal is in position before installation.

2. Install the mounting screws and tighten to 4 - 4.7 Nm (36 - 42 in. lbs.).
3. Connect the pump motor harness.
4. Connect the harnesses to the CAB and lock the connectors.
5. Connect battery.