Idle Speed/Throttle Actuator - Electronic: Service and Repair

Fig. 25 Sensor Electrical Connectors - Typical:

The IAC motor is located on the back of the throttle body.

REMOVAL
1. Remove engine cover.
2. Remove air cleaner assembly.
3. Disconnect electrical connector from IAC motor.

Fig. 18 Mounting Bolts (Screws) - IAC Motor:

4. Remove two mounting bolts (screws).
5. Remove IAC motor from throttle body.

INSTALLATION
1. Install IAC motor to throttle body.
2. Install and tighten two mounting bolts (screws) to 7 Nm (60 in. lbs.) torque.
3. Install electrical connector.
4. Install air cleaner assembly.
5. Install engine cover.