Trunk / Liftgate: Locations

This power liftgate module is located on the vehicles left side D-pillar just below the motor assembly.

The power liftgate system has its own door control module, located on the vehicles left body D-pillar behind the trim panel.

The latch assembly is located in the bottom center of the power liftgate, below the exterior liftgate handle switch.

The pinch sensor or sensors are located along the right and left sides of the power liftgate, just above the body line.

The liftgate handle switch is an power release switch and is located in the rear light bar assembly just above the license plate.

This full open switch is located on the gear motor housing and is used to signal the power liftgate module when the liftgate is in the full open position.

This lift gear and rod assembly are located in the left rear of the vehicle and are visible without removing the D-pillar trim.

The latch is located in the lower center of the liftgate assembly.

The exterior handle switch is a electronic release switch mounted to the rear license plate lamp housing assembly, located just above the license plate.