Installation

Standard Differential / Rear Axle - 9 1/4 inch

INSTALLATION
1. Apply a coating of hypoid gear lubricant to the differential bearings, bearing cups, and threaded adjusters. A dab of grease can be used to keep the adjusters in position.
2. Install the differential assembly into the housing.






3. Install the differential bearing caps in their original locations (Fig. 33).
4. Install bearing cap bolts and tighten the upper bolts to 14 Nm (10 ft. lbs.). Tighten the lower bolts finger-tight until the bolt head is seated.
5. Perform the differential bearing preload and adjustment procedure.

NOTE: Be sure that all bearing cap bolts are tightened to their final torque of 136 Nm (100 ft. lbs.) before proceeding.

6. Install axle shafts.






7. Apply a 1/4 inch bead of red Mopar(R) Silicone Rubber Sealant or equivalent to the housing cover (Fig. 34).

CAUTION: If cover is not installed within 3 to 5 minutes, the cover must be cleaned and new RTV applied or adhesion quality will be compromised.

8. Install the cover and any identification tag and tighten cover bolts to 41 Nm (30 ft. lbs.).
9. Fill differential with lubricant to bottom of the fill plug hole. Refer to the Lubricant Specifications for the correct quantity and type.
10. Install the fill hole plug and lower the vehicle.
11. Track-LokTM differential equipped vehicles should be road tested, by making 10 to 12 slow figure-eight turns. This maneuver will pump the lubricant through the clutch discs to eliminate a possible chatter noise complaint.