Overhead Console Bracket Replacement

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console from the overhead console bracket. Refer to Overhead Console in the Removal and Installation for the procedures.
3. Remove the headliner from the roof panel. Refer to Headliner in the Removal and Installation of Body for the procedures.

Fig.4 Overhead Console Bracket Remove/Install:

4. Remove the two screws that secure the front of the overhead console bracket to the roof front header.
5. Using a sharp utility knife, cut through the double-faced tape that secures the rear flange of the overhead console bracket to the roof panel.
6. Remove the overhead console bracket from the roof panel.

INSTALLATION
1. Remove any remnants of the old double-faced tape from the roof panel and the rear flange of the overhead console bracket and clean these areas with a suitable solvent to remove any traces of grease, oil or adhesive residue. When installing the overhead console bracket, always apply a new piece of double-faced tape to the rear flange of the bracket.
2. Align the two locating pins on the front of the overhead console bracket with the receptacles in the roof front header.
3. Lower the rear flange of the overhead console bracket from the roof panel far enough to access and remove the release paper from the double-faced tape.
4. Push upward firmly and evenly on the rear flange of the overhead console bracket over the double-faced tape to ensure complete adhesion to the roof panel.
5. Install and tighten the two screws that secure the front of the overhead console bracket to the roof front header. Tighten the screws to 1.9 Nm (17 in. lbs.).
6. Install the headliner onto the roof panel. Refer to Headliner in the Removal and Installation of Body for the procedures.
7. Install the overhead console onto the overhead console bracket. Refer to Overhead Console in the Removal and Installation for the procedures.
8. Reconnect the battery negative cable.