Service Procedure

1. Open the driver's door and move the driver's seat to the full rearward position.





2. Locate the unused electrical connector under the driver's seat near the transmission tunnel (Figure 1).

NOTE:
If the male side of the unused connector is missing, order male connector CBDPF422 for 2001 model year vehicles or CBDPF423 for 2002/2003 model year vehicles.

3. Slide the red locking tab towards the driver's side of the vehicle to release the primary lock on the connector.

4. Squeeze the tail end of the male connector to release the secondary connector lock and pull the connector apart.

5. Inspect the wiring harness side of the connector for corrosion and/or debris. If corrosion and/or debris is found, use Electrolyte Detection and Neutralizing Spray (P/N CBEJD201) to clean the corrosion and/or debris from the connector.





6. Install the connector end seal, retainer cap and cavity plugs into the empty male connector (removed in Step 4) as shown in Figure 2.

7. Install the male connector onto the unused wiring harness connector and engage the red lock tab by sliding the lock tab towards the passenger side of the vehicle (Figure 2).