Tail Lamp Unit Replacement

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open the liftgate.

Fig.24 Tail, Brake, Turn Signal And Back-up Lamp:

3. Remove the screws attaching the lamp housing to the liftgate opening.
4. Separate lamp from quarter panel.

Fig.25 Tail Lamp Connector:

5. Disengage the positive lock on the wire connector.
6. Depress the lock tab on the side of the body harness connector.
7. Disengage the wire connector from tail lamp circuit board.
8. Separate the tail lamp from the vehicle.

INSTALLATION
1. Position the tail lamp on vehicle.
2. Engage the wire connector into the tail lamp circuit board.
3. Engage the positive lock on the wire connector.
4. Engage the hook to hold outer end of the lamp to the quarter panel opening.
5. Install the screws attaching tail lamp to the liftgate opening.
6. Connect the battery negative cable.