Instrument Panel Center Bezel

INSTRUMENT PANEL CENTER BEZEL

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Insert the trim stick (special tool #C-4755) or equivalent between access cover and center bezel gently pry outward.

Fig.8 Instrument Panel Center Bezel:

3. Carefully pry the access cover from the instrument panel (Fig. 8).
4. Remove the two center bezel attaching screws.
5. Using a trim stick or equivalent, gently pry out on the edge of the instrument panel center bezel and pull outward.
6. Disconnect the wire connectors to the accessory switches and HVAC control.
7. Remove the instrument panel center bezel from the vehicle.

INSTALLATION
1. Place center bezel near opening and connect the wire connectors to the accessory switches and HVAC control.
2. Position the center bezel over the retaining slots and firmly snap the instrument panel center bezel into place (Fig. 8).
3. Install the two center bezel attaching screws.
4. Install the screw access cover to the bottom of the center bezel.