Cooling System Filling

STANDARD PROCEDURE - REFILLING COOLING SYSTEM ENGINE
DO NOT WASTE REUSABLE COOLANT. If the solution is clean, drain the coolant into a clean container for reuse.
1. Install the cylinder block drain plugs (if removed). Coat the threads with Mopar Thread Sealant with Teflon.
2. Close the radiator draincock.

CAUTION: Failure to purge air from the cooling system can result in an overheating condition and severe engine damage.

3. Fill system using a 50/50 mixture antifreeze and low mineral content water. Stop filling when the level in the degas bottle has reached the top of the COLD FILL RANGE.
4. Start and operate the engine until the thermostat opens (upper radiator hose is warm to the touch).
5. If necessary, add a 50/50 mixture of anti-freeze and water to the degas bottle to maintain the proper coolant level in the degas bottle.
6. Install the radiator cap.