Instrument Panel Trim Bezel - Driver

REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

1. Using a trim stick C-4755 or equivalent, at notch in the bottom, remove the drivers side end cap.
2. Remove the drivers side cowl trim panel. Cowl Trim

Fig.17 Lower Drivers Side Bezel:

3. Remove the two screws. (Fig. 17)
4. Using a trim stick C-4755 or equivalent, release the top clips and tilt the bezel down.
5. Disconnect the adjustable pedal switch electrical connector, if equipped.
6. Lower the bezel down fully and remove from the lower hooks.

INSTALLATION
1. Position the bezel onto the lower hooks and lift up.
2. Connect the adjustable pedal switch electrical connector, if equipped.
3. Seat the upper attachment clips fully.
4. Install the two screws.
5. Position the end cap and seat fully.
6. Install the drivers side cowl trim panel. Cowl Trim