Cylinder Block Assembly: Service and Repair

REMOVAL
1. Remove distributor.
2. Remove the intake manifold.





3. Insert Distributor Drive Shaft Bushing Puller Tool C-3052 into old bushing and thread down until a tight fit is obtained (Fig. 33).
4. Hold puller screw and tighten puller nut until bushing is removed.

INSTALLATION
1. Slide new bushing over burnishing end of Distributor Drive Shaft Bushing Driver/Burnisher Tool C-3053. Insert the tool and bushing into the bore.





2. Drive bushing and tool into position, using a hammer (Fig. 34).





3. As the burnisher is pulled through the bushing, the bushing is expanded tight in the block and burnished to correct size (Fig. 35). DO NOT ream this bushing.

CAUTION: This procedure MUST be followed when installing a new bushing or seizure to shaft may occur.

4. Install the intake manifold.
5. Install the distributor.