Extension Housing Seal

EXTENSION HOUSING SEAL

REMOVAL
1. Raise vehicle.
2. Mark propeller shaft and axle yoke for alignment reference.
3. Disconnect and remove propeller shaft.





4. Remove old seal with Seal Remover C-3985-B (Fig. 88) from overdrive housing.

INSTALLATION
1. Place seal in position on overdrive housing.





2. Drive seal into overdrive housing with Seal Installer C-3995-A (Fig. 89).
3. Carefully guide propeller shaft slip yoke into housing and onto output shaft splines. Align marks made at removal and connect propeller shaft to rear axle pinion yoke.