Parking Brake System: Service and Repair

PEDAL

REMOVAL
1. Raise and support vehicle.
2. Loosen adjuster nut at the tensioner.
3. Remove front cable from the cable connector.
4. Lower vehicle.





5. Push ball end of cable out of pedal clevis on the pedal assembly with small screwdriver.
6. Compress cable housing retainer at pedal bracket and remove cable. Compress cable housing retainer with 1/2 boxed end wrench.
7. Disconnect the park brake lamp switch.
8. Remove the park brake release from the knee blocker.
9. Remove mounting bolts.
10. Remove assembly.

INSTALLATION
1. Install park brake pedal assembly and install mounting bolts.
2. Tighten mounting bolts to 54 Nm (40 ft. lbs.).
3. Seat cable housing retainer into pedal bracket.
4. Install ball end of cable into clevis on the pedal assembly.
5. Raise vehicle and install front cable into the cable connector.
6. Perform park brake adjustment procedure.
7. Lower vehicle.