Manifold Pressure/Vacuum Sensor: Service and Repair

REMOVAL

Fig.34 MAP Sensor Location:

The MAP sensor is located in the left/rear side of the intake manifold.

The MAP sensor is located in the left/rear side of the intake manifold (Fig. 34).
1. Disconnect electrical connector from MAP sensor.

Fig.35 MAP Sensor Removal/Installation:

2. Remove MAP sensor from intake manifold.
3. Discard sensor O-ring .

INSTALLATION
The MAP sensor is located in the left/rear side of the intake manifold.
1. Clean sensor mounting hole of rust or contaminants.
2. Install new O-ring to sensor. Apply clean engine oil to sensor O-ring and sensor threads.
3. Install MAP sensor into intake manifold. Tighten to 14 Nm (10 ft. lbs.) torque.
4. Connect sensor electrical connector.