Antenna, Radio: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove glove box from instrument panel.

Antenna Cable:

3. Disconnect antenna cable connector from extension cable.
4. Remove right kick trim panel.
5. Disengage rubber grommet insulator from door hinge pillar.
6. Pull antenna cable through hinge pillar into opening between door hinges.
7. Hoist and support vehicle on safety stands.
8. Remove front wheel.
9. Remove front wheelhouse splash shield.

Antenna Mast:

10. Remove antenna mast from antenna base.

Antenna Cap Nut Remove/Install - Typical:

11. Remove plastic cap from the cap nut. Using cap nut tool, remove cap nut holding antenna base to front fender.
12. Remove antenna base from under front fender.

INSTALLATION
1. Install antenna base to underside of front fender.
2. Install cap nut holding antenna base to front fender.
3. Install plastic cap to the cap nut.
4. Install antenna mast to antenna base.
5. Install front wheelhouse splash shield.
6. Install front wheel.
7. Lower vehicle.
8. Push antenna cable through opening in hinge pillar.
9. Insert rubber grommet into door hinge pillar.
10. Install kick panel.
11. Connect antenna cable connector to extension cable.
12. Install glove box to instrument panel
13. Connect the battery negative cable.